chemlok® 218e adhesive

1. ​Use sandblasting, sandpaper grinding and solvent cleaning or alkaline degreasing to clean the metal surface. The surface of the resin material should also be properly ground or chemical treatment.
2. Chemlok 218E should be applied as soon as possible after metal surface preparation and can be applied by brushing, dipping, spraying, rolling, etc. Can be coated according to Appropriate amount of Chemlok 218E can be diluted as needed.
3. When coating Chemlok 218E, the metal surface temperature should be controlled below 60°C. The drying time for natural drying (25°C) is about 30 minutes. powerful Drying is about 60°C ~80°C×10 minutes.
4. Chemlok 218E can achieve the best adhesive performance when the dry film thickness is 18~25μ.
5. After dilution, it must be fully stirred to make the solid content disperse evenly.
6. Chemlok218E needs to be completely dry before bonding with rubber vulcanization. After the rubber is vulcanized, the adhesive will also harden, but under the high temperature after molding When the bonding layer is still fragile, care should be taken to prevent the bonding surface from being affected by external forces when removing the film.

Shelf Life One year after manufacture, store in unopened containers at 21-27°C. Avoid storing in direct sunlight, please store in the original container in a well-ventilated place.

Before using this or any LORD product, consult the Safety Data Sheet (SDS) and product label for safe use and handling instructions. For industrial/commercial use only. Those who use this product must receive relevant training in advance. Not for domestic use. Not for general consumer use.